|
|
| Line 1: |
Line 1: |
| − | == Hand Placement ==
| |
| | | | |
| − | Navigate to the Hand Placement page ('''Production > 100% Traceability > Hand Placement''').<br>
| |
| − |
| |
| − | [[Image:2014-01-30_11-47-33.jpg|center|500px]]Choose the Production Line and Workstation, then enter the Board Barcode and click Submit. If material is enough, then will
| |
| − |
| |
| − | pop up a message:Successful,in the right section of the Portlet will show the "Scan Time", "Board Barcode", "Scanned By" info.
| |
| − |
| |
| − | If material is not enough, then will pop up a message:Error-Workstation material has run out when scan! Some things need to
| |
| − |
| |
| − | be verified before using 100% traceability hand placement function.
| |
| − |
| |
| − | <br>
| |
| − |
| |
| − | [[Image:100handboard.png|737x214px|100handboard.png]]
| |
| − |
| |
| − | <br> First, The choosed Production Line must on line. Also you can Add a Production Line and Workstation by yourself at other
| |
| − |
| |
| − | Portlets in PTS, then Set it on line.
| |
| − |
| |
| − | Second, the Part Number must set 100 Traceability at "PN Extra Info" Portlet.<br>
| |
| − |
| |
| − | [[Image:Pn.png|553x267px|Pn.png]]
| |
| − |
| |
| − | <br>
| |
| − |
| |
| − | <br>
| |
| − |
| |
| − | <br>
| |
| − |
| |
| − | When hint Error, we need to load material of the same Part Number for scanning. you can click "Load Material" Portlet to load
| |
| − |
| |
| − | material to workstation. After this you can repeat the actions:Choose Production Line, workstation, and input a Board Barcode
| |
| − |
| |
| − | for scannig. Then will pop up a dialog box(as Figure). Operator can choose the Old Component and New Component to the
| |
| − |
| |
| − | corresponding Designator.<br>
| |
| − |
| |
| − | [[Image:100handload.png|745x302px|100handload.png]]<br>
| |
| − |
| |
| − | == Fujitrax Rework ==
| |
