Difference between revisions of "SOP-42Q-MES0041 100 Traceability"
Dane parker (talk | contribs) (Created page with "== Hand Placement == To Use Hand Placement Portlet, click PTS-->100% Traceability-->Hand Placement. Choose the Production Line and Workstation, then input the Board Barco...") |
|||
| Line 1: | Line 1: | ||
| − | == Hand Placement == | + | == Hand Placement == |
| − | |||
| − | Choose the Production Line and Workstation, then | + | Navigate to the Hand Placement page ('''Production > 100% Traceability > Hand Placement''').<br> |
| + | |||
| + | [[Image:2014-01-30_11-47-33.jpg|center|500px]]Choose the Production Line and Workstation, then enter the Board Barcode and click Submit. If material is enough, then will | ||
pop up a message:Successful,in the right section of the Portlet will show the "Scan Time", "Board Barcode", "Scanned By" info. | pop up a message:Successful,in the right section of the Portlet will show the "Scan Time", "Board Barcode", "Scanned By" info. | ||
Revision as of 18:07, 30 January 2014
Hand Placement
Navigate to the Hand Placement page (Production > 100% Traceability > Hand Placement).
Choose the Production Line and Workstation, then enter the Board Barcode and click Submit. If material is enough, then will
pop up a message:Successful,in the right section of the Portlet will show the "Scan Time", "Board Barcode", "Scanned By" info.
If material is not enough, then will pop up a message:Error-Workstation material has run out when scan! Some things need to
be verified before using 100% traceability hand placement function.
First, The choosed Production Line must on line. Also you can Add a Production Line and Workstation by yourself at other
Portlets in PTS, then Set it on line.
Second, the Part Number must set 100 Traceability at "PN Extra Info" Portlet.
When hint Error, we need to load material of the same Part Number for scanning. you can click "Load Material" Portlet to load
material to workstation. After this you can repeat the actions:Choose Production Line, workstation, and input a Board Barcode
for scannig. Then will pop up a dialog box(as Figure). Operator can choose the Old Component and New Component to the
corresponding Designator.
